Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
6. Remove the reverse servo.
Installation
1. Install the reverse servo. Tighten the bolts in the sequence shown in two stages.
^
Stage 1: Tighten bolts to 5 Nm (44 inch lbs.)
^
Stage 2: Tighten bolts to 11 Nm (8 ft. lbs.)
2. CAUTION: Lubricate the fluid filter seals with clean automatic transmission fluid or they may be damaged.
NOTE: Make sure that the fluid filter seals are correctly seated on the filter.
Lubricate the seals and install a new transmission fluid filter.
3. NOTE: The transmission fluid pan gasket is reusable, clean and inspect for damage. If not damaged, the gasket should be reused.
Install the fluid pan gasket on the pan.
