Explorer 2WD V8-302 5.0L VIN P SFI (1999)
4.
Reprogram the PCM following the procedures found in the Powertrain Control/Emissions Diagnosis (PC/ED) Workshop Manual. Refer to the
PCM Calibration Information Chart shown.
5.
Verify the repair following the Transmission Drive Cycle test as written in the appropriate model year Workshop Manual. (Section 307-1A).
NOTE:
THE TRANSMISSION DRIVE CYCLE TEST MUST BE PERFORMED EXACTLY AS WRITTEN. DO NOT SHORT CUT OR MISS ANY
STEPS OR THE PROCEDURE WILL NOT BE ABLE TO VALIDATE THE REPAIR.