Explorer 2WD V8-302 5.0L VIN P SFI (1999)
2
Remove the EVAP canister with bracket assembly.
7. Remove the canister vent solenoid and the evaporative emission tube.
1
Remove the canister vent solenoid.
2
Remove the evaporative emission canister purge sleeve.
3
Remove the evaporative emission tube.
8. Remove the evaporative emission canister from the evaporative emission canister bracket.
INSTALLATION
1. To install, reverse removal procedure.
NOTE: Lubricate all O-rings with Merpol (R) ESE-M99B144-B or equivalent before installation.
2. Leak test the evaporative emissions system. See: Testing and Inspection/Component Tests and General Diagnostics/Evaporative Emission
Canister Assembly Leak Test
3. Perform the Evaporative Emission Running Loss Monitor Repair Verification Drive Cycle.
