Explorer 2WD V8-302 5.0L VIN P SFI (1999)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the Crankshaft Position (CKP) sensor.
1
Disconnect the CKP sensor electrical connector.
2
Remove the screws.
3
Remove the CKP sensor.
INSTALLATION
NOTE: Be sure sensor wiring is routed away from the battery cable.
1. Install the CKP sensor.
1
Position the CKP sensor.
2
Install the screws.
3
Connect the CKP sensor electrical connector.
2. Connect the battery ground cable.