Explorer 2WD V8-302 5.0L VIN P SFI (1999)
See Figure 3.
Multifunction Switch Replacement
MULTIFUNCTION SWITCH REPLACEMENT
1.
Turn the ignition switch lock cylinder to the RUN position. Then, push the ignition switch lock cylinder release tab with a punch while pulling out
the ignition switch lock cylinder.
2.
Remove the tilt wheel handle by turning the handle counterclockwise (it equipped).
3.
Remove the upper to lower steering column shroud retaining screws and remove the shrouds.
4.
Remove the two (2) multifunction switch retaining screws and disconnect the electrical connectors. See Figure 4.
5.
Inspect the multifunction switch electrical connector pins to make sure they are not loose or pushed out in the connectors. See Figure 5.
6.
Connect the new multifunction switch, making sure the electrical connectors snap into place and are fully seated.
