Explorer 2WD V8-302 5.0L VIN P SFI (1999)
Parts Ordering Information
Parts will not be direct for this program. Order your part requirements through normal order processing channels as noted in the table.
NOTE:
DWE will not accept claims listing a separate Multifunction Switch part number. Dealers must use the kit part number listed above for completion of
the program. The jumper harness must be installed to correct the safety concern addressed by this recall.
DEALER PRICE
For latest prices, refer to:
^
DOES II
^
Updated Price Book
EXCESS STOCK RETURN
Exess stock returned for credit must have been purchased from Ford Customer Service Division in accordance with Policy Bulletin 4000.
Overview
When performing this service procedure, you will:
^
Install a resistor jumper harness to correct a safety issue.
^
Replace the multifunction switch to correct a customer satisfaction concern.
^
Check the multifunction switch electrical connector pins to make sure they are not loose or pushed out in the connectors.
Resistor Jumper Harness Installation
RESISTOR JUMPER HARNESS INSTALLATION
1.
Record the radio stations and disconnect the battery ground cable.
2.
Disconnect the ABS electrical connector located on the left-hand fender. See Figure 1.
