Explorer 2WD V8-302 5.0L VIN P SFI (1999)
Power Seat Control Module: Service and Repair
Driver Seat Module (DSM)
REMOVAL
WARNING:
^
ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING AN AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) VEHICLE
AND WHEN HANDLING AN AIR BAG MODULE. THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN
ACCIDENTAL DEPLOYMENT.
^
AFTER DEPLOYMENT, THE AIR BAG SURFACE CAN CONTAIN DEPOSITS OF SODIUM HYDROXIDE, A PRODUCT OF THE
GAS GENERANT COMBUSTION THAT IS IRRITATING TO THE SKIN. WASH YOUR HANDS WITH SOAP AND WATER
AFTERWARD.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
1. Remove the seat track assembly.
NOTE: Be sure to read and follow all air bag warnings.
2. Remove the Driver Seat Module (DSM).
1. Remove the screws.
2. Disconnect the electrical connectors.
3. Remove the DSM.
INSTALLATION
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
1. Install the DSM.
1. Connect the electrical connectors.
2. Position the DSM.
3. Install the screws.
2. Install the seat track.
NOTE: Be sure to read and follow all air bag warnings.
3. Check the restraint system for proper operation.
4. If equipped, prove out the air bag system.