Explorer 2WD V8-302 5.0L VIN P SFI (1999)
11. Unroll he seat backrest trim cover to the second row of hog rings.
12. Install the hog rings.
13. Unroll the seat backrest trim cover to the bottom row of hog rings.
14. Install the hog rings.
15. Connect the hook and loop fastener to the seat backrest trim cover.
1. Pull the seat backrest trim cover completely down.
2. Reach up inside the seat backrest and grab the plastic above the hook and loop. Remove enough plastic to expose the hook and loop.
16. Hook the trim cover clip.
NOTE: If equipped, make sure that the seat backrest heating element wire is aligned with and off-set from the lower seat backrest trim cover
J-clip.
