Explorer 2WD V8-302 5.0L VIN P SFI (1999)
2. Use the half-inch drill provided in D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.
3. Apply a suitable lubricant to the M14x1.5 tap provided in D-Ring Installation Kit and tap new threads.
NOTE: After each rotation, back off tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.
4. Use a threaded insert provided in the D-Ring Installation Kit and screw it into the retapped hole until it is slightly below the surface.
5. Use a hammer to lightly tap the installation tool provided in the D-Ring Installation Kit several times to seat the insert keys.
NOTE: If the two bolts on the height adjuster are not stripped, install the height adjuster.
6. Install the B-pillar trim panel.
-
Check the restraint system for normal operation.
