Explorer 2WD V8-302 5.0L VIN P SFI (1999)
Evaporative Vapor Pressure Sensor: Service and Repair
REMOVAL
1. Remove the fuel tank.
2. Remove the fuel tank pressure sensor.
1
Disconnect the electrical connector.
2
Press down and rotate the fuel tank pressure sensor counterclockwise and remove it from the fuel tank.
CAUTION: The fuel tank pressure sensor must be disengaged from the fuel tank before it can be removed. Push down and rotate the fuel
tank pressure sensor counterclockwise to disengage it from the fuel tank. Failure to do so can cause damage to the fuel tank pressure sensor or
the fuel tank.
INSTALLATION
1. To install, reverse removal procedure.
2. Leak test. See: Powertrain Management/Emission Control Systems/Evaporative Emissions System/Testing and Inspection/Component Tests and
General Diagnostics/EVAP System Leak Test
3. Perform the Evaporative Emissions Running Loss Monitor Repair Verification Drive Cycle.
