Explorer 2WD V8-4.6L (2008)
1. NOTE: The recliners are synchronized. Do not rotate the recliner shaft until completely installed.
Install the recliner motor in the following sequence.
1
Position the recliner shaft through the recliner motor and inboard recliner.
2
Install a new one-way push clip onto the recliner shaft at the inboard power recliner.
3
Turn the recliner motor so the recliner motor mounting hole lines up with the screw hole in the inboard power recliner.
4
Install the recliner motor bolt.
5
Connect the recliner motor electrical connector.
2. Roll the backrest trim cover down, attach the hook-and-loop strips and connect the backrest trim cover lower J-clip.
3. Position the backrest trim cover to the inboard and outboard recliners and install the plastic rivets.
4. Install the front seat backrest.
5. Install the front seat.
