Explorer 2WD V8-4.6L (2008)
4. Install the 2 brake pedal bracket bolts.
^
Tighten to 22 Nm (16 lb-ft).
5. Install the 3 accelerator pedal bracket nuts.
^
Tighten to 7 Nm (62 lb-in).
6. If equipped with power adjustable pedals, connect the adjustable pedal motor electrical connector.
7. If equipped with adjustable pedals, connect the accelerator pedal electrical connector.
8. Position the brake booster push rod to the brake pedal.
9. Install the new booster push rod clevis locking pin.
10. Connect the steering column to the steering column shaft and install the bolt.
^
Tighten to 30 Nm (22 lb-ft).
11. Position the steering column opening cover and install the 2 screws.
12. CAUTION: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch or the speed control deactivator
switch. These switches must be installed with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest
position. Installing these switches with the brake pedal in any other position will result in incorrect adjustment and may damage the
switches.
Install the stoplamp switch.
13. Install the speed control deactivator switch.
14. Repower the SRS. For additional information, refer to Air Bag Systems.
