Explorer 2WD V8-4.6L (2008)
Disconnect the brake booster solenoid electrical connector.
4. NOTE: The booster push rod clevis locking pin is a one-time use only part. Anytime the booster push rod clevis locking pin is removed, a new
booster push rod clevis locking pin should be used.
Remove the booster push rod clevis locking pin and discard.
5. Disconnect the brake booster rod from the brake pedal and position aside.
6. NOTE: Use new nuts when installing the brake booster.
Remove the 4 brake booster nuts and the booster.
^
To install, tighten to 22 Nm (16 lb-ft).
7. To install, reverse the removal procedure.