Explorer 2WD V8-4.6L (2008)
^
Tighten to 8 Nm (71 lb-in) and then add additional torque if needed to stiffen the joint.
2. NOTE: Install new exhaust Y-pipe dual catalytic converter-to-muffler assembly gasket and nuts.
Install the exhaust Y-pipe-dual catalytic converter-to-muffler assembly new gasket, bolts and new nuts.
^
Tighten to 40 Nm (30 lb-ft).
3. NOTE: RH shown, LH similar.
Tighten the exhaust Y-pipe dual catalytic converter-to-exhaust manifold nuts.
^
Tighten to 40 Nm (30 lb-ft).
4. Install the transmission support crossmember.
5. Connect the HO2S and catalyst monitor sensors electrical connectors.
6. Check to see if the exhaust system isolators are at zero load. If the exhaust system isolators are not at zero load, then carry out the exhaust system
alignment procedure.
