Explorer 2WD V8-4.6L (2008)
-
To install, tighten to 6 Nm (53 lb-in).
11. Disconnect the auxiliary harness electrical connector.
12. Remove the auxiliary heater core and evaporator core housing.
13. To install, reverse the removal procedure.
-
Clean and lubricate the coolant hoses with plain water only if needed.
-
Install new O-ring seals.
-
Install a new TXV filter.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
14. Fill the engine cooling system.
15. Evacuate, leak test and charge the refrigerant system.