Explorer 2WD V8-4.6L (2008)
6. Install the 4 stabilizer bar bracket nuts.
^
Tighten to 48 Nm (35 lb-ft).
7. Using the jack, raise the suspension until the distance between the center of the hub and the lip of the fender is equal to the measurement taken in
Step 1 (curb height) in Removal.
8. Install the stabilizer bar link and new link nut and grommet.
^
Tighten the nut to 30 Nm (22 lb-ft).
9. CAUTION: The upper arm outboard bolts must be installed with the bolt head toward the front of the vehicle or wheel damage may
occur.
Install the 2 upper arm outboard bolts and the 2 upper arm outboard nuts.
^
Tighten to 225 Nm (166 lb-ft).
10. Remove the jack.
11. Install the wheel and tire.
