Explorer 2WD V8-4.6L (2008)
2. Install 4 new O-rings on the transmission fluid cooler tube ends.
3. NOTE: Inspect the transmission case to make sure that the old O-rings are not stuck in the transmission case.
Position the transmission fluid cooler tubes into the transmission, then install the bolt for the transmission cooler tube retainer.
^
Tighten to 25 Nm (18 lb-ft).
4. Install the transmission fluid cooler tube bracket and install the transmission fluid cooler tube bracket nut.
^
Tighten to 12 Nm (9 lb-ft).
