Explorer 2WD V8-4.6L (2008)
Remove the rear window glass.
Installation
1. NOTE: Remove as much as possible of the foam core butyl from the body and rear window glass prior to installation.
Install the rear window glass.
-
Apply foam core butyl to the window. Overlap the foam core butyl by 25 mm (0.984 in) at the bottom middle of the rear window glass.
-
Carefully install the rear window glass into the body opening.
2. Install the 12 rear window glass mounting nuts.
-
Tighten to 3 Nm (27 lb-in).
-
Test the rear window glass for water leaks.
3. Install both C-pillar upper trim panels.
4. Install the rear window glass regulator.
-
Initialize the rear window regulator motor. For additional information, refer to Window Motor Initialization - Rear. See: Power Window
Motor/Back Window Motor/Testing and Inspection