Explorer 2WD V8-4.6L VIN 8 (2006)
Front Door Exterior Handle: Service and Repair
Door Handle
EXTERIOR FRONT DOOR HANDLE
Removal and Installation
1. Remove the front door trim panel.
2. Position the watershield aside.
3. If equipped, disconnect the door lock cylinder actuating rod.
4. Open the clip and disconnect the exterior front door handle actuating rod.
5. Remove the 2 exterior front door handle nuts.
-
To install, tighten to 9 Nm (80 lb-in).
6. Remove the exterior front door handle.
7. To install, reverse the removal procedure.
