Explorer 2WD V8-4.6L VIN 8 (2006)
2. Remove the floor console trim ring.
3. Remove the front floor console center finish panel.
-
Remove the screws and remove the center finish panel.
-
Disconnect the power point electrical connector.
4. Remove the 2 front floor console forward bolts.
5. NOTE: Position both front seats in the full REARWARD position.
Remove the 2 front floor console middle bolts.
6. NOTE: Position both front seats in the full FORWARD position.
Remove the 2 front floor console rear bolts.
7. Remove the front floor console.
8. To install, reverse the removal procedure.
