Explorer 2WD V8-4.6L VIN 8 (2006)
Power Seat Switch: Service and Repair
Seat Control Switch
SEAT CONTROL SWITCH
Worldwide Diagnostic System (WDS)
Special Tool(s)
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the front seat and depower the supplemental restraint system (SRS).
2. Remove the cushion side shield.
1
If equipped, remove the clip and manual recline handle.
2
If equipped, pull and remove the manual lumbar control knob.
3
Remove the scrivet.
4
Release the cushion side shield front clip.
5
From under the cushion side shield, release the 3 hook retainers.
6
Pull out on the cushion side shield at the back and release the pin-type retainer.
7
Remove the seat control switch knob and separate the seat control switch from the cushion side shield.
-
Remove the cushion side shield.
3. Disconnect and remove the seat control switch.
4. To install, reverse the removal procedure.
5. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
6. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS. See: Restraint Systems/Air Bag
Systems/Testing and Inspection/Component Tests and General Diagnostics/Zero Seat Weight Test
