Explorer 2WD V8-4.6L VIN 8 (2006)
Removal
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will
render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the brake flow bolt and position the brake hose aside.
^
Discard the 2 copper washers.
3. Remove the 2 brake caliper bolts and remove the brake caliper.
4. Remove the brake pads from the brake caliper.
Installation
1. Install the brake pads to the brake caliper.
2. Position the brake caliper and install the 2 brake caliper bolts.
^
Tighten to 32 Nm (24 ft. lbs.).
3. Using 2 new copper washers, position the brake hose and install the brake hose flow bolt.
^
Tighten to 35 Nm (26 ft. lbs.).
4. Bleed the brake caliper.
5. Test the brake system operation.
