Explorer 2WD V8-4.6L VIN 8 (2006)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Removal and Installation
1. Disconnect the battery ground cable.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Disconnect the wheel speed sensor electrical connector.
4. Disconnect the wheel speed harness from the retainers.
5. Remove the wheel speed sensor bolt and the wheel speed sensor.
^
To install, tighten to 8 Nm (71 inch lbs.).
6. To install, reverse the removal procedure.
