Explorer 2WD V8-4.6L VIN 8 (2006)
Rotate the crankshaft clockwise, as viewed from the front, positioning the crankshaft damper spoke at the 6 o'clock position and the timing mark
indentation at the 7 o'clock position.
10. NOTICE: Engine is not freewheeling. Camshaft procedure must be followed exactly or damage to valves and pistons will result.
NOTE: The Timing Chain Wedge tool must be installed square to the timing chain and the engine block.
NOTE: Engine front cover removed for clarity.
Install the special tool in the LH timing chain as shown.
11. NOTICE: Do not remove the Timing Chain Wedge tool at any time during assembly. If the special tool is removed or out of placement, the
engine front cover must be removed and the engine must be retimed. For additional information, refer to Timing Drive Components. See: Timing
Components
NOTICE: The timing chain must be installed in its original position onto the camshaft phaser and sprocket using the scribed marks, or damage to
valves and pistons will result.
NOTE: RH shown, LH similar.
