Explorer 2WD V8-4.6L VIN 8 (2006)
14. Clean and inspect the LH camshaft bearing caps.
-
The camshaft front thrust bearing cap contains an oil metering groove. Make sure the groove is free of foreign material.
15. NOTICE: Damage to the camshaft phaser and sprocket assembly will occur if mishandled or used as a lifting or leveraging device.
NOTICE: Only use hand tools to remove the camshaft phaser and sprocket bolt or damage may occur to the camshaft or camshaft phaser and
sprocket.
NOTICE: Do not remove the Timing Chain Wedge tool at any time during assembly. If the special tool is removed or out of placement, the
engine front cover must be removed and the engine must be retimed. For additional information, refer to Timing Drive Components. See: Timing
Components
Remove the bolt and withdraw the camshaft from the camshaft phaser and sprocket assembly, leaving the camshaft phaser and sprocket assembly
in place.
Discard the bolt and washer.
16. Inspect the camshaft phaser and sprocket for damage. For additional information, refer to Camshaft Phaser and Sprocket. See: In-Vehicle Repair
Installation
1. Lubricate the camshaft and camshaft journals with clean engine oil.
2. NOTICE: Do not remove the Timing Chain Wedge tool at any time during assembly. If the special tool is removed or out of placement, the
engine front cover must be removed and the engine must be retimed. For additional information, refer to Timing Drive Components. See: Timing
Components
NOTICE: Damage to the camshaft phaser and sprocket assembly will occur if mishandled or used as a lifting or leveraging device.
NOTE: Do not allow the camshaft roller followers to move out of position when installing the camshaft.
