Explorer 2WD V8-4.6L VIN 8 (2006)
Install the camshaft into the camshaft phaser and sprocket assembly and onto the head. Install a new camshaft phaser and sprocket bolt finger-tight.
3. NOTICE: Do not remove the Timing Chain Wedge tool at any time during assembly. If the special tool is removed or out of placement, the
engine front cover must be removed and the engine must be retimed. For additional information, refer to Timing Drive Components. See: Timing
Components
NOTICE: The timing chain must be installed in its original position onto the camshaft phaser and sprocket using the scribed marks, or damage to
valves and pistons will result.
NOTE: RH shown, LH similar.
Verify the camshaft phaser and sprocket and timing chain scribe marks are still in alignment.
4. NOTE: Do not allow the camshaft roller followers to move out of position when installing the camshaft.
Install the camshaft bearing caps in their original locations.
-
Lubricate the camshaft bearing caps with clean engine oil.
-
Position the front camshaft bearing cap.
-
Position the remaining camshaft bearing caps.
-
Install the bolts loosely.
