Explorer 2WD V8-4.6L VIN 8 (2006)
4. Position the RH valve cover with a new gasket on the cylinder head and tighten the bolts in the sequence shown.
^
Tighten to 10 Nm (89 inch lbs.).
5. Connect the crankcase breather tube to the RH valve cover.
6. Attach the heater hose retainer to the RH valve cover.
7. Attach the wiring harness pin-type retainer to the front of the RH valve cover.
8. Attach the wiring harness retainers to the RH valve cover studs.
9. Connect the RH VCT oil control solenoid electrical connector.
10. Connect the engine wiring harness to the PCM.
^
Position the wiring harness and attach the wiring harness pin-type retainer to the PCM bracket.
^
Connect the in-line electrical connector.
^
Connect the 2 PCM electrical connectors.
11. Install the RH ignition coils.
12. Install the air cleaner and the air cleaner outlet pipe.
