Explorer 2WD V8-4.6L VIN 8 (2006)
Position the worm gear 13 - 26 mm (0.5 - 1.0 inch) away from the sensor and tighten the worm gear.
^
Tighten to 3 Nm (27 inch lbs.).
6. CAUTION: The sensor, cradle and strap can be damaged by incorrect tire mounting or dismounting. Mount the tire only as instructed.
Install the tire onto the wheel.
7. NOTE: A new tire pressure sensor is shipped in an OFF mode (or battery saver mode) and must be turned ON before it can be trained. To turn
the sensor ON, inflate the tire to the recommended inflation pressure and wait at least 2 minutes, then continue with the sensor training procedure.
Train the tire pressure sensor(s).
