Explorer 2WD V8-4.6L VIN 8 (2006)
Evaporative Canister Filter: Service and Repair
DUST SEPARATOR
Removal and Installation
WARNING:
-
The evaporative emissions system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still presents
the danger of explosion or fire. Disconnect the battery ground cable from the battery to minimize the possibility of an electrical spark
occurring, possibly causing a fire or explosion if fuel vapor or liquid fuel are present in the area. Failure to follow these instructions can
result in personal injury.
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable
mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Disconnect the fuel vapor hose from the dust separator.
4. Disconnect the fuel filler pipe vapor hose from the dust separator.
5. Remove the bolt and the dust separator.
-
To install, tighten to 9 Nm (80 lb-in).
6. To install, reverse the removal procedure.
-
Lubricate the vapor hoses with clean engine oil to ease installation.
7. Leak test the evaporative emission system.
8. Carry out the evaporative emission repair verification drive cycle. See: Powertrain Management/Emission Control Systems/Evaporative
Emissions System/Testing and Inspection/Evaporative Emission Repair Verification Drive Cycle