Explorer 2WD V8-4.6L VIN 8 (2006)
Removal and Installation
1. Drain the engine cooling system.
2. Remove the intake manifold.
3. Rotate the accessory drive belt tensioner clockwise and detach the belt from the generator pulley.
4. Disconnect the electrical connector.
5. Loosen the generator nuts.
^
To install, tighten to 25 Nm (18 ft. lbs.).
6. Remove the generator bracket-to-coolant crossover bolts, and position the generator, bracket and wiring harness aside as an assembly.
^
To install, tighten to 10 Nm (89 inch lbs.).