Explorer 2WD V8-4.6L VIN 8 (2006)
Heater Hose: Service and Repair
Auxiliary Heater Outlet and Inlet Line - Front
AUXILIARY HEATER OUTLET AND INLET LINE - FRONT
Removal and Installation
1. Remove the RH running board.
2. Drain the engine coolant.
3. Remove the RH rear wheel.
4. Release the front auxiliary heater line front clamps and disconnect the heater hoses.
5. Release the front auxiliary heater line rear clamps and disconnect the heater hoses.
6. Remove the 3 auxiliary line bracket nuts.
-
To install, tighten to 6 Nm (53 lb-in).
7. Remove the 3 auxiliary line bracket bolts.
-
To install, tighten to 6 Nm (53 lb-in).
8. Remove the 6 auxiliary line brackets.
9. Remove the front auxiliary heater outlet and inlet lines.
10. To install, reverse the removal procedure.
