Explorer 2WD V8-4.6L VIN 8 (2006)
6. Remove the rear suction accumulator-to-compressor line.
-
Discard the O-ring seal.
7. NOTE: The compressor suction fitting nut can be accessed through the RH wheel well.
Remove the compressor suction fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
8. Remove the front suction accumulator-to-compressor line.
9. To install, reverse the removal procedure.
-
Install new O-ring seals and a new gasket seal.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
10. Evacuate, leak test and charge the refrigerant system.