Explorer 2WD V8-4.6L VIN 8 (2006)
2. Remove the fuel tank shield from the fuel tank.
3. Disconnect the fuel tank pressure sensor electrical connector.
4. Disconnect the 3 fuel tank pressure sensor and tube assembly quick connect couplings from the fuel pump module and the vapor vent valves.
5. Remove the fuel tank pressure sensor and tube assembly.
6. To install, reverse the removal procedure.
7. Leak test the evaporative emission system.
8. Carry out the evaporative emission repair verification drive cycle. See: Emission Control Systems/Evaporative Emissions System/Testing and
Inspection/Evaporative Emission Repair Verification Drive Cycle
