Explorer 2WD V8-4.6L VIN 8 (2006)
5. Close and push the special tool into the open side of the cage.
6. Separate the spring lock coupling.
Connect - Type II
1. NOTE: Apply clean engine oil to O-ring seals.
Inspect and clean both spring lock coupling ends. Install new O-ring seals and garter springs if necessary.
2. CAUTION: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the
tube.
Fit the male end into the female end and push until the garter spring snaps over the flared end of the female end.