Explorer 2WD V8-4.6L VIN 8 (2006)
13. Position the steering column cover panel and Install the 2 screws.
14. Connect the harness locator at the front of the SJB.
15. Connect the accelerator pedal electrical connector.
16. Install the RH instrument panel side mount bolts.
-
Tighten to 30 Nm (22 lb-ft).
17. Install the RH instrument panel side finish panel.
18. Install the RH door weather seal.
19. Position the 2 instrument panel center braces and install the 4 bolts, 4 nuts.
-
Tighten to 9 Nm (80 lb-in).
20. Install the 2 upper instrument panel bolts and the 2 bolt covers.
-
Tighten to 30 Nm (22 lb-ft).
21. Install the transmission selector lever.
22. Install the floor console.
23. Connect the battery.
24. NOTE: When successful, this step provides the calibration necessary for SJB operation and clears DTC B2477. The clearing of the DTC
indicates the calibration data has been successfully downloaded to the SJB.
Download the SJB configuration information from the diagnostic tool to the SJB.
25. NOTE: When successful, this step clears DTCs B2868, B2869, B2870 and B2871. The clearing of these DTCs indicates the SJB has recognized
the tire pressure sensors during the training procedure.
Train the tire pressure sensors.
26. Clear the DTCs.
27. NOTE: This step is required to clear DTC C2780, cause the SJB to exit the manufacturing mode, and to be sure there are no other concerns with
the newly programmed SJB.
Carry out the SJB on-demand self-test.
28. CAUTION: If the module configuration upload/download is successful, then the RKE transmitters do not need to be reprogrammed to
the vehicle. However, if the module configuration upload/download is unsuccessful and as-built data must be used to configure the
module, then ALL of the customer's RKE transmitters must be reprogrammed to the vehicle.
Program the RKE transmitters.
