Explorer 2WD V8-4.6L VIN 8 (2006)
Child Seat Tether Attachment: Service and Repair
Child Safety Seat Tether Anchor - Third Row
CHILD SAFETY SEAT TETHER ANCHOR - THIRD ROW
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensors [BTS] if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies should
be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
1. Remove the liftgate scuff plate trim panel.
2. Remove the tether anchor bolt(s) and tether anchor(s).
-
To install, tighten to 40 Nm (30 lb-ft).
