Explorer 2WD V8-4.6L VIN 8 (2006)
retractor assembly must be installed if the safety belt assembly's ALR feature or any other safety belt function is not operating correctly when inspected
according to the functional inspection procedures. Failure to install a new belt and retractor assembly could increase the risk of injury in collisions.
NOTE: Seat is removed and exploded for clarity.
1. Fold the seat and tilt to the E-Z entry position.
2. Remove the 3 screws and inboard recliner outer cover side shield.
3. Remove the bolt and safety belt anchor.
-
To install, tighten to 55 Nm (41 lb-ft).
4. Release the backrest trim cover retainers.
5. Remove the safety belt bezel.
6. NOTE: Use care when separating the seat back trim cover from the hook and loop strip, or the hook and loop strip can be torn from the backrest
foam pad.
Invert the backrest trim cover.
7. CAUTION: Use care when separating the seat back trim cover from the hook and loop strip, or the hook and loop strip can be torn from
the backrest foam pad.
Release the hook and loop strips.
8. Remove the pin-type retainer and safety belt retractor cover and insulator.
9. Remove the bolt and safety belt retractor.
-
To install, tighten to 75 Nm (55 lb-ft).
10. To install, reverse the removal procedure.
11. Check the active restraint system for correct operation.
