Explorer 2WD V8-4.6L VIN 8 (2006)
6. NOTE: Typical driver air bag module with 2 squibs shown, other air bag modules with multiple squibs similar.
For air bag modules with multiple squibs, twist together a wire from each squib then repeat for the remaining wires from each squib.
7. Make a jumper harness to deploy the air bag module.
-
Obtain 2 wires (20 gauge minimum) at least 9.14 meters (30 feet) long and strip both ends of each wire.
-
At one end of the jumper harness, connect the wires together.
8. Using the end of the jumper harness that the wires are not connected together, attach each wire of the jumper harness to each wire of the air bag
module or to the twisted-together wires if multiple squibs. Use tape or other insulating material to make sure that the leads do not make contact
with each other.
Driver air bag modules
