Explorer 2WD V8-4.6L VIN 8 (2006)
6. Move the seat to the rearward most position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
7. NOTE: Note the position of where the locator tab on the OCS rail goes through the OCS rail shield and into the rear mounting point of the seat
track for installation.
Remove the 2 front bolts and the affected OCS rail and shield.
Installation
NOTE: If installing a new seat track, position the seat track where the seat will be in the rearward most position before starting installation of the OCS
rails.
1. WARNING: The occupant classification sensor rail shield is an aid to prevent foreign material and contaminants from entering the
occupant classification sensor rail. Make sure the occupant classification sensor rail shield is present, is not damaged and is correctly
installed to the occupant classification sensor rail. Failure to follow these instructions may increase the risk of personal injury or death in
a crash.
NOTE: Make sure the OCS rail shield is seated correctly on the OCS rail. Align the locator tab to the shield.
Position the OCS rail shield on the OCS rail. Then position the OCS rail and shield on the seat track while noting the correct installation of the
OCS rail locator tab into the seat track.
2. NOTE: To make sure of correct installation, the OCS rail bolts must be installed in the sequence shown.
While holding the OCS rail and shield firmly in position, install the OCS rail front mounting position rear bolt.
