Explorer 2WD V8-4.6L VIN 8 (2006)
1. Inspect the O-ring seal for damage. Install a new seal if damaged. Lubricate the O-ring seal with petroleum jelly to prevent damage to the O-ring
seal.
1
Install the TSS sensor into the transmission.
2
Tighten the TSS sensor screw.
^
Tighten to 14 Nm (10 ft. lbs.).
2. Connect the TSS sensor electrical connector.
3. Install the shift cable and bracket.
^
Tighten to 40 Nm (30 ft. lbs.).
4. NOTE: If the shield is loose on the cable, replace the shield.
Install the cable shield.