Explorer 2WD V8-4.6L VIN 8 (2006)
fuse 17 (10A) from the SJB.
4. Turn the ignition ON and visually monitor the air bag indicator for at least 30 seconds. The air bag indicator will remain lit continuously (no
flashing) if the correct RCM fuse has been removed. If the air bag indicator does not remain lit continuously, remove the correct RCM fuse before
proceeding.
5. Turn the ignition OFF.
6. WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing
or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood
latches.
The front impact severity sensors are located on the radiator support bracket above the lower front splash shield.
The front door side impact sensors are located in the first row doors, behind the door trim panel.
The C-pillar side impact sensors (if equipped) are located on the C-pillar.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).
Disconnect the battery ground cable and wait at least one minute.
7. Remove the 2 driver air bag module bolts (1 shown).
8. NOTE: Note the position of the 3 driver air bag module wiring connectors for installation.
Disconnect the 3 driver air bag module electrical connectors and remove the driver air bag module.
