Explorer 2WD V8-4.6L VIN 8 (2006)
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in
major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do not use a part of
lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct detention of these parts.
1. Measure the distance from the center of the hub to the lip of the fender with the vehicle in a level, static ground position (curb height).
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Using a suitable jack support the lower control arm near the lower ball joint.
4. Remove and discard the upper ball joint nut.
^
To install, tighten to 55 Nm (41 ft. lbs.).
5. CAUTION: Do not use a hammer to separate the ball joint from the wheel 1nuckle or damage to the wheel knuckle can result.
CAUTION: Do not damage the ball joint boot while installing the special tool.
