Explorer 2WD V8-4.6L VIN 8 (2006)
2. Using a suitable spring compressor, compress the spring until the tension is released from the shock absorber.
3. CAUTION: Use the holding feature to prevent the shock absorber rod from turning while removing and installing the nut.
CAUTION: When installing the shock rod nut, make sure the shock rod and bushing are centered in the upper mount before tightening the nut.
Remove and discard the shock absorber rod nut.
^
To install, tighten to 56 Nm (41 ft. lbs.).
4. Remove the shock absorber.
5. Remove the washer and upper mount bushing.
6. Remove the upper shock absorber mount.
7. Remove the dust boot.
8. Carefully release the spring compressor and remove the coil spring.
9. NOTE: When installing the shock rod nut, make sure the shock rod and bushing are centered in the upper mount before tightening the nut.
NOTE: Make sure that the upper shock mount stud, shock rod and shock lower bushing are aligned before tightening shock absorber rod nut.
