ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

A/T - 5R55S Converter Housing Fluid Leaks|Page 5744 > < A/T - Loss Of 2nd/3rd/5th Gears/Ratio DTC's Set|Page 5735
Page 1
background image

Bell Housing: Customer Interest
A/T - 5R55S Converter Housing Fluid Leaks

TSB 06-10-5

05/29/06

5R558 - TRANSMISSION FLUID LEAK

FORD:
2006 Mustang, Explorer

LINCOLN:
2006 Lincoln LS

MERCURY:
2006 Mountaineer

ISSUE
Some 2006 Explorer 4dr, Mountaineer, Mustang vehicles built between 8/1/2005 and 12/7/2005, and Lincoln LS vehicles built between 9/1/2005 and
1/31/2006, with a 5R55S transmission may exhibit a fluid leak coming from within the converter housing. The leak may be coming from the bolt holes
located at the 5 or 7 o'clock positions on the fluid pump cover.

ACTION
Follow the Workshop Manual (WSM), Section 307-01A, Leak Inspection Procedures to determine the correct source of the leak. If the bolt hole area is
the source do not replace the pump assembly. Use the following Service Procedure to correct the condition.

SERVICE PROCEDURE

1.

Drain transmission fluid by removing the drain plug (large plug) and allow the fluid to drain.

2.

Reinstall the drain plug and tighten to 19 lb-ft (26 N.m).

3.

Using WSM, Section 307-01A, Removal - Transmission, remove the transmission.

NOTE

IT IS NOT NECESSARY TO COMPLETELY REMOVE THE DRIVE SHAFT OR EXHAUST FROM THE LINCOLN LS. THE PROCEDURE
CAN BE PERFORMED BY REMOVING THE TRANSMISSION END OF THE DRIVESHAFT AND SECURING IT OUT OF THE WAY AND
ONLY THE CATALYTIC CONVERTER NEEDS TO BE REMOVED.

4.

Remove the torque converter.

5.

Remove and discard both bolts on fluid pump cover from both the 5 and 7 o'clock positions.

6.

Clean the converter housing area and the bolt hole surface with Motorcraft Metal Surface Cleaner only.

7.

Apply only Motorcraft Ultra Silicone Sealant to the pump cover surface around the two bolt holes.

8.

Install two new fluid pump bolts, and torque bolt to 18 lb-ft (25 N.m).

9.

Reinstall torque converter.

10.

Using WSM, Section 307-01A, Installation - Transmission, install the transmission.

11.

Follow WSM, Section 307-01A, Fluid Level Check and reset fluid level.

12.

Verify repair.

WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage

A/T - 5R55S Converter Housing Fluid Leaks|Page 5744 > < A/T - Loss Of 2nd/3rd/5th Gears/Ratio DTC's Set|Page 5735