Explorer 2WD V8-4.6L VIN 8 (2006)
Fluid Fill Reference
Fluid Fill Reference
NOTE: Left side of case shown.
1. Using the diagnostic tool (WDS), monitor the transmission fluid temperature (TFT) using PID: TFT.
2. Start the vehicle.
3. NOTE: Engine idle speed is approximately 650 rpm.
While proceeding with this procedure, run the engine until the transmission fluid temperature is between 27 - 49°C (80 - 120°F).
4. Move the range selector lever slowly through each gear, stopping in each position and allowing the transmission to engage.
5. Place the range selector lever in the PARK position.
6. With the engine running and the vehicle set as close to level as possible, position it on a hoist.