Explorer 2WD V8-4.6L VIN 8 (2006)
18. Check the operation of the transmission by moving the range selector lever slowly through each gear, stopping in each position and allowing the
transmission to engage.
Transmission Fluid Drain and Refill - Automated Equipment
Transmission Fluid Drain and Refill - Automated Equipment
Special Tool
Material
Draining
CAUTION: Use only clean automatic transmission fluid specified for this transmission. Do not use supplemental transmission fluid additives,
treatments or clean agents. The use of these materials may affect transmission operation and result in damage to internal transmission components.
CAUTION: Always refer to the instructions supplied with the flush and fill machine.
1. With the vehicle in PARK, position it on a hoist.
2. Use a suitable flush and fill machine to change the fluid.
3. When connecting the flush and fill machine, connect the machine to the fluid cooler tube after the fluid cooler on the cooler return line. This will
help remove any foreign material trapped in the fluid coolers.
Refill
1. Use only clean automatic transmission fluid.
2. Once the fluid exchange has been completed, disconnect the flush and fill machine.
Reconnect any disconnected fluid cooler tubes.
3. Lower the vehicle.
4. With the engine running, check and adjust the transmission fluid level and check for any leaks. If fluid is needed, add fluid in increments of
0.24-liter (0.5-pint) until the correct level is achieved.
Transmission Fluid Drain and Refill - Without Torque Converter Drain Plug
Transmission Fluid Drain and Refill - Without Torque Converter Drain Plug
