Explorer 2WD V8-4.6L VIN 8 (2006)
14. Apply a maximum of 206.85 kPa (30 psi) to the open end of the vacuum/pressure hose from the special tool. Fluid will immediately start flowing
out of the special tool into the transmission.
15. NOTE: Do not overfill the transmission. The fluid level must be at the upper level of the crosshatch mark. If the transmission fluid is overfull,
fluid must be drained to the correct level.
Reinstall the fluid level indicator only back into the fill plug hole to check the fluid level. Repeat this until a consistent reading is established.
16. A "FULL" reading must be established.
17. Install the fluid fill plug.
^
Tighten to 35 Nm (26 ft. lbs.).
Transmission Fluid Level Check
Transmission Fluid Level Check
