Explorer 2WD V8-4.6L VIN 8 (2006)
Install the one end of the filter into the rubber hose with a clamp.
^
Tighten the hose clamp.
8. Using a suitable length of hose, install the other end of the filter into the tubing ferrule hose assembly with 2 clamps.
^
Tighten the hose clamps.
9. Clean a section of the transmission fluid pan, then install the sticker.
10. Fill the transmission with clean automatic transmission fluid.
^
Verify for correct operation.
^
Check the filter for leaks.
Fluid Pan, Gasket and Filter
Fluid Pan, Gasket and Filter
Material
Material
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
