Explorer 2WD V8-4.6L VIN 8 (2006)
Install the transmission fluid pan and gasket and loosely install the screws.
5. Tighten the screws in a crisscross sequence.
^
Tighten to 11 Nm (8 ft. lbs.).
6. CAUTION: Damage will occur to the solenoid body assembly if the screw is tightened above the specification.
NOTE: Always install new O-ring seals on vehicle harness connector.
NOTE: Clean the area around connector to prevent contamination of the solenoid body connector.
NOTE: Use petroleum jelly to lubricate the O-ring seals to aid in the installation process.
Install and lubricate new O-ring seals on the transmission connector and connect the connector.
^
Tighten to 5 Nm (44 inch lbs.).
7. Fill the transmission.