Explorer 2WD V8-4.6L VIN 8 (2006)
3. Remove and discard the rear axle wheel end nut.
^
To install, tighten to 275 Nm (203 ft. lbs.).
4. CAUTION: Do not use a hammer to separate the rear axle halfshaft assembly from the hub. Damage to the threads and internal CV joint
components can result.
Using the special tool, press the outboard CV joint until it is loose in the hub.
5. Remove the brake cable retainer screw.
^
To install, tighten to 20 Nm (15 ft. lbs.).
6. Remove and discard the outboard toe link nut and back out the bolt for clearance.
^
To install, tighten to 350 Nm (259 ft. lbs.) at curb ride height.
